DID call route in E1 Gateway
DID through the E1 Gateway is done by following a few steps
1- on the gateway you have to create an inbound route to PRI digital trunk and the pattern should be (x.)
2- create an outbound route from the gateway to the ucm and the pattern should be (x.)
3- on the ucm create inbound from the gateway and the pattern should be (xxYYY,xxxYYY,xxxxYYY,xxxxxYYY,xxxxxxYYY) where YYY is the last three-digit of the number required to create the special DID
For example the required number was 0403386410
so the pattern used in the inbound route on the ucm is
xx410
xxx410
xxxx410
xxxxx410
xxxxxx410
1- on the gateway you have to create an inbound route to PRI digital trunk and the pattern should be (x.)
2- create an outbound route from the gateway to the ucm and the pattern should be (x.)
3- on the ucm create inbound from the gateway and the pattern should be (xxYYY,xxxYYY,xxxxYYY,xxxxxYYY,xxxxxxYYY) where YYY is the last three-digit of the number required to create the special DID
For example the required number was 0403386410
so the pattern used in the inbound route on the ucm is
xx410
xxx410
xxxx410
xxxxx410
xxxxxx410
xxxxxxx410
xxxxxxxx410
attached an image of the inbound configuration and the documentation file from grandstream
xxxxxxxx410
attached an image of the inbound configuration and the documentation file from grandstream
Related Articles
UCM feature Configuration (Users Privilege custom)
Users Privilege custom #1Amine @August 30, 2021 09:31 Hi Mustapha, Thank you for contacting Grandstream Networks EMEA support center Can you please clarify if you what you need to achieve is configuring user accounts for the agents with restricted ...